Soundtracs Topaz Project 8 with meter bridge
Starting from the top of the input channel, the Project 8 has a scribble strip and switches for phase reverse, phantom power, flip and bus. The gain pot has a 10dB to 60dB range for mic and a -20dB to 30dB range for line-level signals.
The channel EQ section has a high-shelving band at 12 kHz, low-shelving at 80 Hz, and two swept-mid EQs. MF1 EQ is sweepable from 350 to 8k Hz, and the MF2 EQ is sweepable from 50 to 1k Hz. All EQ has a +/-15dB range and a center detent. EQ bypass switches are provided. A dedicated 2-band EQ devoted to the Monitor input consists of high-/low-shelving EQs (80 and 12k Hz), both with a +/-15 dB range.
The aux section uses a four-of-six arrangement, meaning that there are six aux send outputs, but only four can be used on a channel at a time. Aux 1 is a pre-fader channel send, and Aux 2 is a pre-fader monitor send; unfortunately, these cannot be switched for post-fader use. Auxes 3 and 4 are post-fader sends and can be switched for use with either the Channel or Monitor input. Switches allow routing Aux 3 to the Aux 5 output and Aux 4 to the Aux 6 output.
Decent condition for a desk of it's age, all channels gains eqs buttons working as they should. Channel 8 on meter on the blink and fader on Ch 1 needs a fix as volume from min to max not correlating correctly. No other issues. Sold with meter bridge. Lots of info about them on gearslutz, eq's sound fantastic imo.
Looking for cash on this one.