Browse categories

DIY vacuum pump for smd components

DIY vacuum pump for smd components
FREE
Do you want it?
Seller:
witnessmenow
Top Seller
Feedback:
76 0
Location:
1 more ads from this seller
Entered/Renewed:
2 days ago
Ad Views:
154
Viewing 1 of 4
DIY vacuum pump for smd components

Description

This has had very little use. It's a Tetra aps400 aerator, but I must have modified it to suck rather than push air (I believe I opened it and changed the position of a valve, it was probably 5 years ago so I can't remember. I'm sure it could be reversed if you want to use it as an aerator again)

I used it a tiny bit as a vacuum pump for placing smd components. It's attached to a plastic syringe with a hole in it, place your finger on the hole sucks the component up, release your finger and the component will release. From what I remember it's better than you think it would be! The photo is it holding a 0603 led

I have a bit of tape over the second port, works as it is but maybe this could be improved!

Comes with about 3m of hose. Have a few angled syringe heads I bought for ir you can have as well.

Collection from Ballinasloe or can post at buyers expense.

Shipping: CollectionPost/Courier
From sellers around the web:
Comments & Requests
witnessmenow 2 days ago
Found additional components for it, added another picture

See more in our Other Electronics category available today

€20.00
€3.00
€15.00
€10.00
€3.00
€7.00
€5.00
€5.00
€30.00
€5.00
€20.00
€300.00
€1.00
€5.00