Condition:
New
BENEFITS of using Ceramizer for 4-stroke engines (CS):
Decreases fuel consumption by 3 to 15 %.
Decreases oil consumption.
Stabilizes and increases compression pressure in cylinders.
Eliminates the so-called "excessive smoking" of engine.
Eliminates dry starts and facilitates engine starting (especially in winter).
Reduces noise, equalizes and increases compression pressure.
Increases the efficiency of engine and dynamics of vehicle.
Regenerates friction surfaces during exploitation, without the need to dismantle. Restored surfaces are moredurable and effective for 70000/100000 km (40000/60000 miles).
Extends operating life of the friction pairs fivetimes.
It replaces most of the repairs, reducing repair costs by a half in comparison with the traditional repair.
Reduces friction coefficient value to less than 0,02 – which is ten times less then steel–steel friction.
Prolongs operating time between oil changes (min 50% increase).
In the event of oil leakage and loss guaranteed continual and safe use of vehicle (engine for up to 500 km/ 300 miles, gearbox, reducer, axle up to 1000 km/ 600 miles).
Protects against corrosion and aggressive chemicals especially when lower quality fuel and lubricants are used.
Decreases exhaust emission of toxic gases.
Protects against piston ring seizure.
Hardens and increases the wear and tear resistance of rubbing surfaces, even 10 -fold. Microhardness- 4000-4500 MPa (400 - 450 kG/mm 2 ) (in comparison microhardness of steel is 60 kG/mm 2 ).
Protection of natural environment.
Ceramizer can be used for any machines and factory units after consulting the Producer.
Ceramizers do not contain teflon, lead, molybdenum, they do not clog oil filters or oil ducts since Ceramizer particles are smaller than filter pores. Ceramizer particles are maximum 2-5 microns in diameter while the apertures of oil filters are over 5 microns. Additionally, the ceramic and metal layer develops only in places where metal rubs against metal so there will be no layer in oil ducts or filters. The Ceramizer is not an oil thickener or so-called “motor-doctor” – one Ceramizer dose is only 5 g. The product does not help with oil leaks through valve gaskets since there is no friction of metal against metal between piston and cylinder.
Newly-created ceramic and metal layer is effective and durable for at least 70 000 km or up to 6000 mth. Afterwards, it is recommended to reapply Ceramizer
DOSAGING - amount of doses, needed for ceramization of friction surfaces see link below
http://www.ceramizer.com/en/instruction-for-4-stroke-engines-cs