Description

Condition: New

EURO6 AdBlue Emulators Disable System:

– AdxBlue system (Fully)
– AdxBlue NOX sensor
– DPF system
– DPF temperature sensors
– DPF regeneration

After installing Euro6 Emulator, you can remove:

– DPF sensors – YES
– NOx sensor – YES
– Adblue temp. sensor (s) – YES
– Adblue pump – YES
– Adblue level sensor – YES
– Adblue ECU – YES

Kindly note: It is possible to disable AdBlue system by installing an AdBlue emulator (programmable device) into the vehicle. You can switch it on/off anytime.

System emulator AdBlue for NOX EMULATOR for Man EURO 6
In device the highest quality of components have been used.
Each device before it reaches the customer is subjected to quality control and tested.
Car AdBlue system can work properly or be out of order.
The device works with both manual and automatic transmission.
Emulator AdBlue completely replaces in the car SCR system:
- Pump
- NOx Sensor
- heaters
- Clogged filters
- Injectors
- Wires
- Temperature sensors
- AdBlue level sensor in the tank
Advantages of AdBlue Emulator:
- No need to refuel AdBlue fluid
- In case of failure any of the modules

EURO6 AdBlue Emulators using guide:

Emulator Man Euro 6 does not need to be learned. You install emulator under the metal cover of AdBlue Pump on the right side behind the cab, and disconnect plug from AdBlue Pump and connect emulator.

Next, you need to remove the fuses:

F894(Multisensor In AdBlue tank)

F738 (+30 Signal of AdBlue pump)

F1084 (NOx sensor Upstream)

Fuse F737 is now fuse of emulator.

Fuse F1109 is the fuse of NOx sensor Downstream and A1191 mufler temperature sensor. This sensor needs to work correctly for DPF regeneration.

Finally, you need to remove Power from NOx downstream sensor. There are two ways options, one is to cut pin 1 in NOx sensor plug, the other way (better) is to remove pin 10 in X3212 plug. This plug is visible on rear of engine on the right side. This is TE plug (16 pin) with yellow key.

Call O87.327 42O3
www.iskygadgets.com